High-speed processing for multi-user, multi-protocol labs. The high-speed J-26 XP can process up to six liters in less than ten minutes, the fastest processing possible of any comparable machine. Three-phase filtration sorts the material into component solids, liquids and gasses. Includes a HEPA (High-efficiency particulate arrestance) filter that makes the centrifuge BioSafe. With a full range of rotors, adapters and sample carriers, the -26 XP offers incredible versatility to support your research needs. Features 6.0L max capacity and a max speed of 26,000 RPM (82,000 x g). The J-26 XP runs 24 microplates at a time (or with adaptors for conical tubes and bottles). Full containment barrier, automatic rotor identification and enhanced biosafety. Compatible with an extensive rotor library, including lightweight carbon fiber designs, fixed-angle, swinging bucket and elutriation. Also compatible with J-Lite rotors. Exclusive Switched Reluctance (SR) Drive for faster accel and decel.

Specifications

Platform Avanti
BioSafe Yes
Acceleration Maximum, Slow or Timed (1-10 minutes, 0-500 rpm)
Deceleration Maximum, Slow, Timed (1-10 minutes from 500-0 rpm) or Off
Speed Control ±|10.00|rpm from 10,000 - 26,000 or equivalent RCF
Timed Run 1 minute-3 hours; Continuous Hold
Max Capacity Volume Range 1.00|6.00|L
Software Virtual Network Computing (VNC), Mobile Fuge app for Apple iOS and Android
Temperature Control ± 2|°C of set temperature after equilibration
Temperature Range(s) 10°C - 40°C in 1 degree increments
Rotor ID Manual
Zonal Capability No
Installation Category II
Humidity Restrictions < 95% (non-condensing)
Finish Powder Coat Paint
Weight 290.00|kg / 639.340560336145|lb
Width 71.00|cm / 27.9527559055118|in
Depth 86.0, 102.0 with air direviter extending|cm / 86.0, 102.0 with air direviter extending|in
Height 86.00|cm (149 cm with door open)
Clearances 7.6 cm (sides) & 16 cm (rear)
Pollution Degree 2
Power Requirements 220 VAC, 50 Hz, 3 Phase

NOT ALL PRODUCTS ARE AVAILABLE IN ALL COUNTRIES
PRODUCT AVAILABILITY AND REGULATORY STATUS DEPENDS ON COUNTRY REGISTRATION PER APPLICABLE REGULATIONS

The listed regulatory status for products correspond to one of the below:
IVD: In Vitro Diagnostic Products. These products are labeled "For In Vitro Diagnostic Use."
ASR: Analyte Specific Reagents. These reagents are labeled "Analyte Specific Reagents. Analytical and performance characteristics are not established."
CE: Products intended for in vitro diagnostic use and conforming to European Directive (98/79/EC). (Note: Devices may be CE marked to other directives than (98/79/EC)
RUO: Research Use Only. These products are labeled "For Research Use Only. Not for use in diagnostic procedures."
LUO: Laboratory Use Only. These products are labeled "For Laboratory Use Only."
No Regulatory Status: Non-Medical Device or non-regulated articles. Not for use in diagnostic or therapeutic procedures.